# AEG dishwasher i10 / i11 code Canonical page: https://getfixfault.com/guides/aeg-dishwasher-i10-i11-code AI-readable URL: https://getfixfault.com/guides/aeg-dishwasher-i10-i11-code.txt Last reviewed: 2026-08-03 ## Direct answer AEG Dishwasher i10 / i11: Water-inlet problem; no water entering. This interpretation applies to AEG dishwasher models listed by the linked official code table in UK / English. ## Exact scope - Brand: AEG - Appliance: Dishwasher - Error code or indicator: i10 / i11 - Model scope: AEG dishwasher models listed by the linked official code table - Region: UK / English ## What users may observe - i10 / i11 is shown on the AEG dishwasher display, indicator, or connected app - The published condition is: Water-inlet problem; no water entering - The affected fill stage does not receive or confirm the expected water supply while i10 / i11 is active - The important observation is when i10 / i11 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Water-inlet problem; no water entering - i10 / i11 does not distinguish household supply, hose, accessible screen, inlet hardware, wiring, or control until the listed checks are completed - Model boundary — apply this interpretation only to AEG dishwasher models listed by the linked official code table ## Verified diagnosis - Photograph the complete i10 / i11 display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG dishwasher models listed by the linked official code table - Confirm that the observed condition matches the published meaning: Water-inlet problem; no water entering - Check that the water tap is fully open - Check household water flow - AEG specifies filling a 5-litre bucket in 30 seconds from one tap - Check the visible inlet hose for a kink, twist, or damage - With the tap closed, clean the inlet-hose filter only as the model manual shows - Check accessible dishwasher filters and drain-hose position - If recently installed or moved, confirm the sink-drain blanking plug was removed ## Evidence-backed actions - AEG identifies i10/i11 as no-water-inlet errors - Open the water tap, check household flow, and straighten a kinked inlet hose - With the tap closed, clean the inlet filter only as the exact manual directs - Check the accessible filters and drain route, then test once - A damaged hose or a persistent code requires an engineer - If i10 / i11 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Switch the dishwasher off before cleaning user-accessible parts. Hidden glass may be present near the filter and pump cover. ## Primary evidence - Source: AEG UK dishwasher error codes - Source URL: https://support.aeg.co.uk/support-articles/article/dishwasher-displays-error-code-i10-i11-al5-c1-beeps-once-or-the-warning-light-flashes-once - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.