# AEG dishwasher i24 code Canonical page: https://getfixfault.com/guides/aeg-dishwasher-i24-code AI-readable URL: https://getfixfault.com/guides/aeg-dishwasher-i24-code.txt Last reviewed: 2026-08-03 ## Direct answer AEG Dishwasher i24: Drain pump blocked by a foreign object. This interpretation applies to AEG dishwashers covered by the linked support article in United Kingdom / English. ## Exact scope - Brand: AEG - Appliance: Dishwasher - Error code or indicator: i24 - Model scope: AEG dishwashers covered by the linked support article - Region: United Kingdom / English ## What users may observe - i24 is shown on the AEG dishwasher display, indicator, or connected app - The published condition is: Drain pump blocked by a foreign object - Water or condensate does not leave through the documented drain path as expected while i24 is active - The important observation is when i24 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Drain pump blocked by a foreign object - i24 does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to AEG dishwashers covered by the linked support article ## Verified diagnosis - Photograph the complete i24 display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG dishwashers covered by the linked support article - Confirm that the observed condition matches the published meaning: Drain pump blocked by a foreign object - Stop the dishwasher and disconnect the mains plug - Remove the filter system - Sponge out residual water - Pull the plastic pump cover up at an angle and inspect the impeller for a foreign object - Remove only visible debris carefully, refit the cover and filter, reconnect power, and run one test - Published check — AEG identifies i24 as a foreign object blocking the drain pump - Published check — Its published procedure is to isolate power, remove the filter and residual water, inspect the pump cover and impeller, remove visible debris, refit the cover and filter, then test once ## Evidence-backed actions - AEG identifies i24 as a foreign object blocking the drain pump - Its published procedure is to isolate power, remove the filter and residual water, inspect the pump cover and impeller, remove visible debris, refit the cover and filter, then test once - Arrange professional help if the code persists - Give service the i24 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Switch the dishwasher off before cleaning user-accessible parts. Hidden glass may be present near the filter and pump cover. ## Primary evidence - Source: AEG support: dishwasher i24 - Source URL: https://support.aeg.co.uk/support-articles/article/dishwasher-displays-error-code-i24-not-draining - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.