# AEG dishwasher i60 / i61 / i69 / i6C code Canonical page: https://getfixfault.com/guides/aeg-dishwasher-i60-i61-i69-i6c-code AI-readable URL: https://getfixfault.com/guides/aeg-dishwasher-i60-i61-i69-i6c-code.txt Last reviewed: 2026-08-03 ## Direct answer AEG Dishwasher i60 / i61 / i69 / i6C: Heating or temperature-sensing fault. This interpretation applies to AEG dishwashers covered by the linked support article in United Kingdom / English. ## Exact scope - Brand: AEG - Appliance: Dishwasher - Error code or indicator: i60 / i61 / i69 / i6C - Model scope: AEG dishwashers covered by the linked support article - Region: United Kingdom / English ## What users may observe - i60 / i61 / i69 / i6C is shown on the AEG dishwasher display, indicator, or connected app - The published condition is: Heating or temperature-sensing fault - The measured temperature condition does not match the operating range represented by i60 / i61 / i69 / i6C - The important observation is when i60 / i61 / i69 / i6C appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Heating or temperature-sensing fault - i60 / i61 / i69 / i6C identifies the temperature condition but does not alone prove a sensor, airflow, heater, refrigerant, wiring, or control fault - Model boundary — apply this interpretation only to AEG dishwashers covered by the linked support article ## Verified diagnosis - Photograph the complete i60 / i61 / i69 / i6C display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG dishwashers covered by the linked support article - Confirm that the observed condition matches the published meaning: Heating or temperature-sensing fault - Check that the incoming water temperature at the connection is not above 60°C - Unplug the dishwasher - Check the user-accessible filters and sump for foam, suds, or debris - Clean the filters and clear accessible foam or suds - Reconnect power, select a suitable cycle, and test once - Arrange an AEG-approved service visit if the code returns - Published check — AEG identifies i60/i61/i69/i6C as heating or temperature-sensing conditions ## Evidence-backed actions - AEG identifies i60/i61/i69/i6C as heating or temperature-sensing conditions - Check that inlet water is no hotter than 60°C, then unplug the dishwasher and clean only the accessible filters and sump of foam, suds, and debris - Reconnect and test one suitable cycle - If it returns, arrange approved service - do not replace a heater or sensor from the code alone - Give service the i60 / i61 / i69 / i6C photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Do not open fixed panels or test live electrical parts. Record the full model number and arrange qualified service if the code returns after the permitted external checks. ## Primary evidence - Source: AEG support: dishwasher i60/i61/i69/i6C - Source URL: https://support.aeg.co.uk/support-articles/article/dishwasher-displays-error-code-i60-i61-i69-i6c - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.