# AEG Dryer E20 error Canonical page: https://getfixfault.com/guides/aeg-dryer-e20-official-code AI-readable URL: https://getfixfault.com/guides/aeg-dryer-e20-official-code.txt Last reviewed: 2026-08-24 ## Direct answer AEG Dryer E20: drainage or pump problem. This interpretation applies to AEG tumble-dryer models covered by the linked UK support article in United Kingdom / English. ## Exact scope - Brand: AEG - Appliance: Dryer - Error code or indicator: E20 - Model scope: AEG tumble-dryer models covered by the linked UK support article - Region: United Kingdom / English ## What users may observe - E20 is shown on the AEG dryer display, indicator, or connected app - The published condition is: drainage or pump problem - Water or condensate does not leave through the documented drain path as expected while E20 is active - The important observation is when E20 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — drainage or pump problem - E20 does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to AEG tumble-dryer models covered by the linked UK support article ## Verified diagnosis - Photograph the complete E20 display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG tumble-dryer models covered by the linked UK support article - Confirm that the observed condition matches the published meaning: drainage or pump problem - Published check — check the external drain hose for a correct connection, twists or blockage, reset once for 30 seconds, and contact service if the code returns - Stop at the published service boundary after these actions - do not add a restart or test cycle that AEG does not specify for E20 - Published check — Give service the E20 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that AEG does not specify for E20 ## Evidence-backed actions - check the external drain hose for a correct connection, twists or blockage, reset once for 30 seconds, and contact service if the code returns - Give service the E20 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Follow the exact model manual. check the external drain hose for a correct connection, twists or blockage, reset once for 30 seconds, and contact service if the code returns Do not open fixed panels or test live circuits. ## Primary evidence - Source: AEG tumble-dryer E20/C2 support - Source URL: https://support.aeg.co.uk/support-articles/article/tumble-dryer-displays-error-message-e20-c2-or-emits-2-beeps-2-flashes - Source checked: 2026-08-24 - Procedure verified: 2026-08-24 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.