# AEG Dryer E40 error Canonical page: https://getfixfault.com/guides/aeg-dryer-e40-official-code AI-readable URL: https://getfixfault.com/guides/aeg-dryer-e40-official-code.txt Last reviewed: 2026-08-24 ## Direct answer AEG Dryer E40: door-closure problem. This interpretation applies to AEG tumble-dryer models covered by the linked UK support article in United Kingdom / English. ## Exact scope - Brand: AEG - Appliance: Dryer - Error code or indicator: E40 - Model scope: AEG tumble-dryer models covered by the linked UK support article - Region: United Kingdom / English ## What users may observe - E40 is shown on the AEG dryer display, indicator, or connected app - The published condition is: door-closure problem - The appliance cannot confirm the documented door, lid, latch, or lock state - The important observation is when E40 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — door-closure problem - E40 does not distinguish an obstruction, seal position, latch, lock, wiring, or control until the external closure checks are complete - Model boundary — apply this interpretation only to AEG tumble-dryer models covered by the linked UK support article ## Verified diagnosis - Photograph the complete E40 display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG tumble-dryer models covered by the linked UK support article - Confirm that the observed condition matches the published meaning: door-closure problem - Published check — remove laundry caught in the seal, clean the accessible seal and close the door until it latches, then arrange service if the code remains - Stop at the published service boundary after these actions - do not add a restart or test cycle that AEG does not specify for E40 - Published check — Give service the E40 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that AEG does not specify for E40 ## Evidence-backed actions - remove laundry caught in the seal, clean the accessible seal and close the door until it latches, then arrange service if the code remains - Give service the E40 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Follow the exact model manual. remove laundry caught in the seal, clean the accessible seal and close the door until it latches, then arrange service if the code remains Do not open fixed panels or test live circuits. ## Primary evidence - Source: AEG tumble-dryer E40/E45 support - Source URL: https://support.aeg.co.uk/support-articles/article/tumble-dryer-displays-error-message-e40-e45 - Source checked: 2026-08-24 - Procedure verified: 2026-08-24 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.