# AEG Dryer E60 error Canonical page: https://getfixfault.com/guides/aeg-dryer-e60-official-code AI-readable URL: https://getfixfault.com/guides/aeg-dryer-e60-official-code.txt Last reviewed: 2026-08-24 ## Direct answer AEG Dryer E60: heating-source problem. This interpretation applies to AEG tumble-dryer models covered by the linked UK support article in United Kingdom / English. ## Exact scope - Brand: AEG - Appliance: Dryer - Error code or indicator: E60 - Model scope: AEG tumble-dryer models covered by the linked UK support article - Region: United Kingdom / English ## What users may observe - E60 is shown on the AEG dryer display, indicator, or connected app - The published condition is: heating-source problem - The appliance cannot confirm the documented door, lid, latch, or lock state - The important observation is when E60 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — heating-source problem - E60 does not distinguish an obstruction, seal position, latch, lock, wiring, or control until the external closure checks are complete - Model boundary — apply this interpretation only to AEG tumble-dryer models covered by the linked UK support article ## Verified diagnosis - Photograph the complete E60 display before changing controls or removing power - Confirm that the full model number is covered by this scope: AEG tumble-dryer models covered by the linked UK support article - Confirm that the observed condition matches the published meaning: heating-source problem - Published check — improve room ventilation, clean the accessible filter, condenser and door seal, then run one time-dry check and contact authorised service if it remains cold - Stop at the published service boundary after these actions - do not add a restart or test cycle that AEG does not specify for E60 - Published check — Give service the E60 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that AEG does not specify for E60 ## Evidence-backed actions - improve room ventilation, clean the accessible filter, condenser and door seal, then run one time-dry check and contact authorised service if it remains cold - Give service the E60 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Follow the exact model manual. improve room ventilation, clean the accessible filter, condenser and door seal, then run one time-dry check and contact authorised service if it remains cold Do not open fixed panels or test live circuits. ## Primary evidence - Source: AEG tumble-dryer E60 support - Source URL: https://support.aeg.co.uk/support-articles/article/tumble-dryer-displays-error-message-e60 - Source checked: 2026-08-24 - Procedure verified: 2026-08-24 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.