# Beko dishwasher P1 / E01 code Canonical page: https://getfixfault.com/guides/beko-dishwasher-p1-e01-code AI-readable URL: https://getfixfault.com/guides/beko-dishwasher-p1-e01-code.txt Last reviewed: 2026-08-03 ## Direct answer Beko Dishwasher P1 / E01: Overfill or leak detected; overflow safety algorithm active. This interpretation applies to Beko dishwasher models covered by the linked Australia support article in Australia / English. ## Exact scope - Brand: Beko - Appliance: Dishwasher - Error code or indicator: P1 / E01 - Model scope: Beko dishwasher models covered by the linked Australia support article - Region: Australia / English ## What users may observe - P1 / E01 is shown on the Beko dishwasher display, indicator, or connected app - The published condition is: Overfill or leak detected; overflow safety algorithm active - Leak protection or a water-detection condition is active; the display does not identify the leak location - The important observation is when P1 / E01 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Overfill or leak detected; overflow safety algorithm active - P1 / E01 confirms the protection condition, not whether the source is a hose, seal, connection, internal component, or installation leak - Model boundary — apply this interpretation only to Beko dishwasher models covered by the linked Australia support article ## Verified diagnosis - Photograph the complete P1 / E01 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Beko dishwasher models covered by the linked Australia support article - Confirm that the observed condition matches the published meaning: Overfill or leak detected; overflow safety algorithm active - Stop the dishwasher and switch it off at the wall - Check and clean the internal filters, the drain outlet, and the sink trap connection - If the unit was recently installed, inspect the visible drain connection for a blockage - Only if the exact Beko manual permits it, pull the unit out and tilt it backwards no more than 45 degrees with a second adult - water may drain out - Restore power and run one controlled test - arrange Beko service if P1/E01 returns ## Evidence-backed actions - Beko identifies P1/E01 as overfill or a leak detected by the overflow safety algorithm - Clear only accessible filter and drain obstructions first - The Beko Australia procedure then allows a controlled rearward tilt of no more than 45 degrees after power is off, because water may drain from the base - Never do this alone or on a built-in unit without following the exact manual - Test once and arrange service if the code returns - Give service the P1 / E01 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Stop the cycle, close the water supply, and isolate power only if the area is dry and access is safe. Do not tilt or open fixed panels. ## Primary evidence - Source: Beko Australia dishwasher help centre - Source URL: https://www.beko.com/au-en/Support/help-center/dishwashers - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.