# Electrolux dishwasher i20 code Canonical page: https://getfixfault.com/guides/electrolux-dishwasher-i20-code AI-readable URL: https://getfixfault.com/guides/electrolux-dishwasher-i20-code.txt Last reviewed: 2026-08-03 ## Direct answer Electrolux Dishwasher i20: Dishwasher did not drain properly. This interpretation applies to Electrolux dishwasher models listed by the linked official code table in US / English. ## Exact scope - Brand: Electrolux - Appliance: Dishwasher - Error code or indicator: i20 - Model scope: Electrolux dishwasher models listed by the linked official code table - Region: US / English ## What users may observe - i20 is shown on the Electrolux dishwasher display, indicator, or connected app - The published condition is: Dishwasher did not drain properly - Water or condensate does not leave through the documented drain path as expected while i20 is active - The important observation is when i20 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Dishwasher did not drain properly - i20 does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to Electrolux dishwasher models listed by the linked official code table ## Verified diagnosis - Photograph the complete i20 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Electrolux dishwasher models listed by the linked official code table - Confirm that the observed condition matches the published meaning: Dishwasher did not drain properly - Stop the dishwasher - Check that the disposer knockout plug was removed if the drain connects to a disposer - Check the visible drain hose for blockage, pinching, or restriction - Confirm the hose is installed at least 32 inches from the floor as Electrolux specifies - Clean the user-accessible glass trap/filter - Clear the code using Cancel, the breaker, or a three-minute unplug only as the model manual permits - Run one controlled test ## Evidence-backed actions - Electrolux identifies i20 as incomplete drainage - Check the disposer knockout plug, visible drain hose, hose height, and user-accessible glass trap/filter - After correcting an external restriction, clear the code by the model's permitted Cancel or power-reset method and run one test - A recurring i20 needs service rather than a drain-pump replacement based on the code alone - If i20 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Switch the dishwasher off before cleaning user-accessible parts. Hidden glass may be present near the filter and pump cover. ## Primary evidence - Source: Electrolux US dishwasher and washer error codes - Source URL: https://owner.electrolux.com/support-articles/kitchen/dishwashers - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.