# GE Appliances Dishwasher C2 error Canonical page: https://getfixfault.com/guides/ge-appliances-dishwasher-c2-official-code AI-readable URL: https://getfixfault.com/guides/ge-appliances-dishwasher-c2-official-code.txt Last reviewed: 2026-08-18 ## Direct answer GE Appliances Dishwasher C2: the total pump-out cycle exceeded seven minutes. This interpretation applies to GE Appliances dishwasher models covered by the official Dishwasher fault-code article; not every code appears on every model in United States / English. ## Exact scope - Brand: GE Appliances - Appliance: Dishwasher - Error code or indicator: C2 - Model scope: GE Appliances dishwasher models covered by the official Dishwasher fault-code article; not every code appears on every model - Region: United States / English ## What users may observe - C2 is shown on the GE Appliances dishwasher display, indicator, or connected app - The published condition is: the total pump-out cycle exceeded seven minutes - Water or condensate does not leave through the documented drain path as expected while C2 is active - The important observation is when C2 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — the total pump-out cycle exceeded seven minutes - C2 does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to GE Appliances dishwasher models covered by the official Dishwasher fault-code article; not every code appears on every model ## Verified diagnosis - Photograph the complete C2 display before changing controls or removing power - Confirm that the full model number is covered by this scope: GE Appliances dishwasher models covered by the official Dishwasher fault-code article; not every code appears on every model - Confirm that the observed condition matches the published meaning: the total pump-out cycle exceeded seven minutes - Confirm that the full model number is covered by this scope: GE Appliances dishwasher models covered by the official Dishwasher fault-code article - not every code appears on every model - Published check — Press RESET to stop the beep, then inspect the accessible drain path before one controlled cycle - Published check — contact service if C2 returns - Stop at the published service boundary after these actions - do not add a restart or test cycle that GE Appliances does not specify for C2 - Published check — Give service the C2 photo, full model and serial number, when it appeared, and the result of every published external check ## Evidence-backed actions - Press RESET to stop the beep, then inspect the accessible drain path before one controlled cycle - contact service if C2 returns - Give service the C2 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Press RESET to stop the beep, then inspect the accessible drain path before one controlled cycle; contact service if C2 returns. Do not open fixed panels or test live circuits. ## Primary evidence - Source: GE Appliances dishwasher error-code support - Source URL: https://products.geappliances.com/appliance/gea-support-search-content?contentId=16673 - Source checked: 2026-08-18 - Procedure verified: 2026-08-18 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.