# GE Appliances Washer/dryer combo Check and Clean Drain Pump Filter error Canonical page: https://getfixfault.com/guides/ge-appliances-v2-washer-dryer-combo-check-and-clean-drain-pump-filter-official-code AI-readable URL: https://getfixfault.com/guides/ge-appliances-v2-washer-dryer-combo-check-and-clean-drain-pump-filter-official-code.txt Last reviewed: 2026-08-18 ## Direct answer GE Appliances Washer/dryer combo Check and Clean Drain Pump Filter: a restriction was detected in the drain area. This interpretation applies to GE Profile UltraFast Combo washer/dryer models covered by the official status article in United States / English. ## Exact scope - Brand: GE Appliances - Appliance: Washer/dryer combo - Error code or indicator: Check and Clean Drain Pump Filter - Model scope: GE Profile UltraFast Combo washer/dryer models covered by the official status article - Region: United States / English ## What users may observe - Check and Clean Drain Pump Filter is shown on the GE Appliances washer/dryer combo display, indicator, or connected app - The published condition is: a restriction was detected in the drain area - Water or condensate does not leave through the documented drain path as expected while Check and Clean Drain Pump Filter is active - The important observation is when Check and Clean Drain Pump Filter appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — a restriction was detected in the drain area - Check and Clean Drain Pump Filter does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to GE Profile UltraFast Combo washer/dryer models covered by the official status article ## Verified diagnosis - Photograph the complete Check and Clean Drain Pump Filter display before changing controls or removing power - Confirm that the full model number is covered by this scope: GE Profile UltraFast Combo washer/dryer models covered by the official status article - Confirm that the observed condition matches the published meaning: a restriction was detected in the drain area - Published check — Isolate power, clean the accessible drain-pump filter using the exact GE Profile manual, and run one test - Stop at the published service boundary after these actions - do not add a restart or test cycle that GE Appliances does not specify for Check and Clean Drain Pump Filter - Published check — Give service the Check and Clean Drain Pump Filter photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that GE Appliances does not specify for Check and Clean Drain Pump Filter ## Evidence-backed actions - Isolate power, clean the accessible drain-pump filter using the exact GE Profile manual, and run one test - Give service the Check and Clean Drain Pump Filter photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Isolate power, clean the accessible drain-pump filter using the exact GE Profile manual, and run one test. Do not open fixed panels or test live circuits. ## Primary evidence - Source: GE Profile UltraFast Combo official status support - Source URL: https://products.geappliances.com/appliance/gea-support-search-content?contentId=000063878 - Source checked: 2026-08-18 - Procedure verified: 2026-08-18 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.