# GE Appliances Washer/dryer combo Spin Light Blinking error Canonical page: https://getfixfault.com/guides/ge-appliances-v2-washer-dryer-combo-spin-light-blinking-official-code AI-readable URL: https://getfixfault.com/guides/ge-appliances-v2-washer-dryer-combo-spin-light-blinking-official-code.txt Last reviewed: 2026-08-18 ## Direct answer GE Appliances Washer/dryer combo Spin Light Blinking: the Combo is correcting an out-of-balance load. This interpretation applies to GE Profile UltraFast Combo washer/dryer models covered by the official status article in United States / English. ## Exact scope - Brand: GE Appliances - Appliance: Washer/dryer combo - Error code or indicator: Spin Light Blinking - Model scope: GE Profile UltraFast Combo washer/dryer models covered by the official status article - Region: United States / English ## What users may observe - Spin Light Blinking is shown on the GE Appliances washer/dryer combo display, indicator, or connected app - The published condition is: the Combo is correcting an out-of-balance load - Water or condensate does not leave through the documented drain path as expected while Spin Light Blinking is active - The important observation is when Spin Light Blinking appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — the Combo is correcting an out-of-balance load - Spin Light Blinking does not distinguish an accessible restriction, hose installation, household drain, pump, wiring, or control until the drain path is checked - Model boundary — apply this interpretation only to GE Profile UltraFast Combo washer/dryer models covered by the official status article ## Verified diagnosis - Photograph the complete Spin Light Blinking display before changing controls or removing power - Confirm that the full model number is covered by this scope: GE Profile UltraFast Combo washer/dryer models covered by the official status article - Confirm that the observed condition matches the published meaning: the Combo is correcting an out-of-balance load - Published check — Redistribute the load evenly and run Drain & Spin or Rinse & Spin once - Published check — arrange service if the condition repeats - Stop at the published service boundary after these actions - do not add a restart or test cycle that GE Appliances does not specify for Spin Light Blinking - Published check — Give service the Spin Light Blinking photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that GE Appliances does not specify for Spin Light Blinking ## Evidence-backed actions - Redistribute the load evenly and run Drain & Spin or Rinse & Spin once - arrange service if the condition repeats - Give service the Spin Light Blinking photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Redistribute the load evenly and run Drain & Spin or Rinse & Spin once; arrange service if the condition repeats. Do not open fixed panels or test live circuits. ## Primary evidence - Source: GE Profile UltraFast Combo official status support - Source URL: https://products.geappliances.com/appliance/gea-support-search-content?contentId=000063878 - Source checked: 2026-08-18 - Procedure verified: 2026-08-18 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.