# GE Appliances Water heater F78 error Canonical page: https://getfixfault.com/guides/ge-appliances-v2-water-heater-f78-official-code AI-readable URL: https://getfixfault.com/guides/ge-appliances-v2-water-heater-f78-official-code.txt Last reviewed: 2026-08-18 ## Direct answer GE Appliances Water heater F78: the leak sensor detected water. This interpretation applies to GE Profile GEOSPRING hybrid heat-pump water heaters made June 2025 onward in United States / English. ## Exact scope - Brand: GE Appliances - Appliance: Water heater - Error code or indicator: F78 - Model scope: GE Profile GEOSPRING hybrid heat-pump water heaters made June 2025 onward - Region: United States / English ## What users may observe - F78 is shown on the GE Appliances water heater display, indicator, or connected app - The published condition is: the leak sensor detected water - Leak protection or a water-detection condition is active; the display does not identify the leak location - The important observation is when F78 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — the leak sensor detected water - F78 confirms the protection condition, not whether the source is a hose, seal, connection, internal component, or installation leak - Model boundary — apply this interpretation only to GE Profile GEOSPRING hybrid heat-pump water heaters made June 2025 onward ## Verified diagnosis - Photograph the complete F78 display before changing controls or removing power - Confirm that the full model number is covered by this scope: GE Profile GEOSPRING hybrid heat-pump water heaters made June 2025 onward - Confirm that the observed condition matches the published meaning: the leak sensor detected water - Published check — Locate visible water only if safe, correct the external source when identified, and call a plumber or GE service if F78 remains - Stop at the published service boundary after these actions - do not add a restart or test cycle that GE Appliances does not specify for F78 - Published check — Give service the F78 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that GE Appliances does not specify for F78 ## Evidence-backed actions - Locate visible water only if safe, correct the external source when identified, and call a plumber or GE service if F78 remains - Give service the F78 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Locate visible water only if safe, correct the external source when identified, and call a plumber or GE service if F78 remains. Do not open fixed panels or test live circuits. ## Primary evidence - Source: GE Appliances GEOSPRING water-heater fault-code support - Source URL: https://products.geappliances.com/appliance/gea-support-search-content?contentId=18020 - Source checked: 2026-08-18 - Procedure verified: 2026-08-18 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.