# Gorenje dishwasher F10 error Canonical page: https://getfixfault.com/guides/gorenje-dishwasher-f10-code AI-readable URL: https://getfixfault.com/guides/gorenje-dishwasher-f10-code.txt Last reviewed: 2026-08-04 ## Direct answer Gorenje Dishwasher F10: The dishwasher has detected too much water. This interpretation applies to Gorenje dishwasher model GV693C60UVAD covered by official manual 875524en in Europe / English manual. ## Exact scope - Brand: Gorenje - Appliance: Dishwasher - Error code or indicator: F10 - Model scope: Gorenje dishwasher model GV693C60UVAD covered by official manual 875524en - Region: Europe / English manual ## What users may observe - F10 appears during a programme - Water may remain in the tub or collect around the appliance - The dishwasher may stop to protect against overfilling ## Causes or fault boundaries - A blocked drainage pump or drain path - A water-level or inlet fault requiring model-specific diagnosis - An installation drain restriction ## Verified diagnosis - Photograph the complete F10 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Gorenje dishwasher model GV693C60UVAD covered by official manual 875524en - Confirm that the observed condition matches the published meaning: The dishwasher has detected too much water - Confirm F10 and record GV693C60UVAD or the exact model shown on the rating plate - Turn off the dishwasher and unplug it - Remove the filters and scoop standing water as the manual shows - Inspect the accessible drainage-pump cover and impeller for a foreign object - Refit the pump cover and filters, then request service if F10 returns - Published check — Gorenje's F10 procedure is limited to unblocking the accessible drainage-pump area - Published check — Do not infer an inlet valve or pump replacement from F10 ## Evidence-backed actions - Gorenje's F10 procedure is limited to unblocking the accessible drainage-pump area - Do not infer an inlet valve or pump replacement from F10 - use service when overfilling continues - Give service the F10 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Turn off the dishwasher and unplug it before checking the pump. Close the water tap if water is entering or leaking; do not run the appliance while it overfills. ## Primary evidence - Source: Gorenje official dishwasher manual 875524en - Source URL: https://partners.gorenje.com/fts/htmlNavodila/875524en.html - Source checked: 2026-08-04 - Procedure verified: 2026-08-04 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.