# Gorenje tumble dryer E03 error Canonical page: https://getfixfault.com/guides/gorenje-tumble-dryer-e03-code AI-readable URL: https://getfixfault.com/guides/gorenje-tumble-dryer-e03-code.txt Last reviewed: 2026-08-04 ## Direct answer Gorenje Dryer E03: The condensate pump is not pumping water to the tank normally. This interpretation applies to Gorenje tumble-dryer models covered by official manual 964250en in Europe / English manual. ## Exact scope - Brand: Gorenje - Appliance: Dryer - Error code or indicator: E03 - Model scope: Gorenje tumble-dryer models covered by official manual 964250en - Region: Europe / English manual ## What users may observe - E03 appears during drying - The dryer stops or leaves condensate where it should not - The code returns after the accessible water path is checked ## Causes or fault boundaries - A blocked condensate path - Lint or debris around the accessible pump or filter area - A pump or control fault requiring service ## Verified diagnosis - Photograph the complete E03 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Gorenje tumble-dryer models covered by official manual 964250en - Confirm that the observed condition matches the published meaning: The condensate pump is not pumping water to the tank normally - Confirm E03 and record the exact model - Stop the programme and let hot surfaces cool - Unplug the dryer and place a shallow container or towels under the condensate path - Check and clean only the user-accessible lint, condensate container, filter, or pump-area maintenance points shown by the exact manual - Reassemble, run one short controlled test, and arrange service if E03 returns - Published check — Clear an accessible condensate restriction and empty or refit the condensate container as the model manual permits - Published check — Do not open the sealed refrigeration system or replace the pump from E03 alone ## Evidence-backed actions - Clear an accessible condensate restriction and empty or refit the condensate container as the model manual permits - Do not open the sealed refrigeration system or replace the pump from E03 alone - If E03 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Let hot surfaces cool, unplug the dryer, and protect the floor from condensate before opening only the user-accessible maintenance area. Do not open the sealed refrigeration circuit. ## Primary evidence - Source: Gorenje official tumble-dryer manual 964250en - Source URL: https://partners.gorenje.com/fts/htmlNavodila/964250en.html - Source checked: 2026-08-04 - Procedure verified: 2026-08-04 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.