# Gorenje tumble dryer E17 Wi-Fi error Canonical page: https://getfixfault.com/guides/gorenje-tumble-dryer-e17-code AI-readable URL: https://getfixfault.com/guides/gorenje-tumble-dryer-e17-code.txt Last reviewed: 2026-08-04 ## Direct answer Gorenje Dryer E17: The dryer cannot connect to the Wi-Fi network for remote control. This interpretation applies to Gorenje tumble-dryer models covered by official manual 964250en in Europe / English manual. ## Exact scope - Brand: Gorenje - Appliance: Dryer - Error code or indicator: E17 - Model scope: Gorenje tumble-dryer models covered by official manual 964250en - Region: Europe / English manual ## What users may observe - E17 appears during setup or remote-control use - The app cannot reach the dryer - Local drying programmes can still operate normally ## Causes or fault boundaries - Weak Wi-Fi signal at the dryer - A changed router or network credential - A network configuration issue rather than a drying-system failure ## Verified diagnosis - Photograph the complete E17 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Gorenje tumble-dryer models covered by official manual 964250en - Confirm that the observed condition matches the published meaning: The dryer cannot connect to the Wi-Fi network for remote control - Confirm E17 and record the exact dryer model - Check whether local drying programmes still operate normally - Verify the dryer is within range of the home Wi-Fi network - Check the router network and credentials using the model's Gorenje Connect procedure - Contact Gorenje support if E17 remains after the network check or if local drying also fails - Published check — Treat E17 as a Wi-Fi connection issue affecting remote control - Published check — Correct only the network configuration covered by the exact manual ## Evidence-backed actions - Treat E17 as a Wi-Fi connection issue affecting remote control - Correct only the network configuration covered by the exact manual - do not open the dryer or infer a communication-board replacement - If E17 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Do not open the dryer or alter mains wiring for E17. If local programmes also fail, stop and diagnose the separate appliance fault before using remote control. ## Primary evidence - Source: Gorenje official tumble-dryer manual 964250en - Source URL: https://partners.gorenje.com/fts/htmlNavodila/964250en.html - Source checked: 2026-08-04 - Procedure verified: 2026-08-04 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.