# Gorenje washing machine E11 error Canonical page: https://getfixfault.com/guides/gorenje-washing-machine-e11-code AI-readable URL: https://getfixfault.com/guides/gorenje-washing-machine-e11-code.txt Last reviewed: 2026-08-04 ## Direct answer Gorenje Washing machine E11: The washing machine has detected too much water. This interpretation applies to Gorenje washing-machine models covered by official manual 964258en in Europe / English manual. ## Exact scope - Brand: Gorenje - Appliance: Washing machine - Error code or indicator: E11 - Model scope: Gorenje washing-machine models covered by official manual 964258en - Region: Europe / English manual ## What users may observe - E11 appears while the washer is filling - The water level is higher than expected - The pump may run while the appliance tries to remove water ## Causes or fault boundaries - An overflow or uncontrolled fill condition - Excessive detergent and resulting foam - An internal inlet or water-level fault requiring diagnosis ## Verified diagnosis - Photograph the complete E11 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Gorenje washing-machine models covered by official manual 964258en - Confirm that the observed condition matches the published meaning: The washing machine has detected too much water - Confirm E11 and watch whether water is still entering - Close the water tap immediately if filling continues - Keep the washer isolated from standing water and do not reconnect it - Record whether the drum overflowed and how much detergent was used - Arrange qualified Gorenje service for the inlet or level-system diagnosis - Published check — Gorenje's official procedure is a stop-and-service boundary when filling continues - Published check — Only correct an obvious excessive-detergent situation after the appliance is safe ## Evidence-backed actions - Gorenje's official procedure is a stop-and-service boundary when filling continues - Only correct an obvious excessive-detergent situation after the appliance is safe - do not attempt an inlet-valve or level-sensor repair - Give service the E11 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Close the water tap immediately if filling continues. Keep away from spilled water and do not reconnect or continue using the washer until the overflow cause is assessed. ## Primary evidence - Source: Gorenje official washing-machine manual 964258en - Source URL: https://partners.gorenje.com/fts/htmlNavodila/964258en.html - Source checked: 2026-08-04 - Procedure verified: 2026-08-04 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.