# Haier Air conditioner F4 error Canonical page: https://getfixfault.com/guides/haier-air-conditioner-f4-official-code AI-readable URL: https://getfixfault.com/guides/haier-air-conditioner-f4-official-code.txt Last reviewed: 2026-08-08 ## Direct answer Haier Air conditioner F4: compressor discharge-temperature protection. This interpretation applies to Haier air-conditioner models covered by the linked Malaysia support article in Malaysia / English. ## Exact scope - Brand: Haier - Appliance: Air conditioner - Error code or indicator: F4 - Model scope: Haier air-conditioner models covered by the linked Malaysia support article - Region: Malaysia / English ## What users may observe - F4 is shown on the Haier air conditioner display, indicator, or connected app - The published condition is: compressor discharge-temperature protection - The measured temperature condition does not match the operating range represented by F4 - The important observation is when F4 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — compressor discharge-temperature protection - F4 identifies the temperature condition but does not alone prove a sensor, airflow, heater, refrigerant, wiring, or control fault - Model boundary — apply this interpretation only to Haier air-conditioner models covered by the linked Malaysia support article ## Verified diagnosis - Photograph the complete F4 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Haier air-conditioner models covered by the linked Malaysia support article - Confirm that the observed condition matches the published meaning: compressor discharge-temperature protection - Published check — Switch the unit off and arrange Haier service - Published check — do not open the electrical or refrigerant system - Stop at the published service boundary after these actions - do not add a restart or test cycle that Haier does not specify for F4 - Published check — Give service the F4 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that Haier does not specify for F4 ## Evidence-backed actions - Switch the unit off and arrange Haier service - do not open the electrical or refrigerant system - Give service the F4 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Isolate the appliance when safe. Switch the unit off and arrange Haier service; do not open the electrical or refrigerant system. Do not open fixed panels or test live circuits. ## Primary evidence - Source: Haier Malaysia air-conditioner error-code support - Source URL: https://www.haier.com/my/service-support/self-service/20250402_259027.shtml - Source checked: 2026-08-08 - Procedure verified: 2026-08-08 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.