# Haier washer Fb code Canonical page: https://getfixfault.com/guides/haier-washer-fb-code AI-readable URL: https://getfixfault.com/guides/haier-washer-fb-code.txt Last reviewed: 2026-08-12 ## Direct answer Haier Washing machine Fb: Leakage or float switch has been triggered. This interpretation applies to Haier washing machines covered by the linked India support article in India / English. ## Exact scope - Brand: Haier - Appliance: Washing machine - Error code or indicator: Fb - Model scope: Haier washing machines covered by the linked India support article - Region: India / English ## What users may observe - Fb is shown on the Haier washing machine display, indicator, or connected app - The published condition is: Leakage or float switch has been triggered - Leak protection or a water-detection condition is active; the display does not identify the leak location - The important observation is when Fb appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Leakage or float switch has been triggered - Fb confirms the protection condition, not whether the source is a hose, seal, connection, internal component, or installation leak - Model boundary — apply this interpretation only to Haier washing machines covered by the linked India support article ## Verified diagnosis - Photograph the complete Fb display before changing controls or removing power - Confirm that the full model number is covered by this scope: Haier washing machines covered by the linked India support article - Confirm that the observed condition matches the published meaning: Leakage or float switch has been triggered - Stop the washer - Power the washer off - Record the Fb code and exact model number - Arrange Haier service - Published check — Haier says Fb appears on some bottom-cover models when water leakage has triggered the float switch - Published check — Its published instruction is to power the washer off and call a service centre - Published check — No DIY leak or float-switch repair is verified ## Evidence-backed actions - Haier says Fb appears on some bottom-cover models when water leakage has triggered the float switch - Its published instruction is to power the washer off and call a service centre - No DIY leak or float-switch repair is verified - Give service the Fb photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Stop the cycle and close the water supply. Disconnect power only if it is safe, and arrange service for continued filling or an internal leak. ## Primary evidence - Source: Haier official Fb washer support - Source URL: https://www.haier.com/in/service-support/self-service/20230625_211560.shtml - Source checked: 2026-08-12 - Procedure verified: 2026-08-12 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.