# Hotpoint dishwasher F02 error Canonical page: https://getfixfault.com/guides/hotpoint-dishwasher-f02 AI-readable URL: https://getfixfault.com/guides/hotpoint-dishwasher-f02.txt Last reviewed: 2026-08-04 ## Direct answer Hotpoint Dishwasher F02: The water-fill solenoid valve has failed. This interpretation applies to Hotpoint dishwasher models covered by the linked UK error-code table in United Kingdom / English. ## Exact scope - Brand: Hotpoint - Appliance: Dishwasher - Error code or indicator: F02 - Model scope: Hotpoint dishwasher models covered by the linked UK error-code table - Region: United Kingdom / English ## What users may observe - F02 is shown by the dishwasher LED sequence - The dishwasher may not fill correctly - The programme may stop before washing begins ## Causes or fault boundaries - A water-fill solenoid-valve failure - A model-specific inlet-control fault ## Verified diagnosis - Photograph the complete F02 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Hotpoint dishwasher models covered by the linked UK error-code table - Confirm that the observed condition matches the published meaning: The water-fill solenoid valve has failed - Record the F02 LED sequence and exact Hotpoint model - Turn off water if the dishwasher is filling unexpectedly - Do not open the inlet valve or mains-connected components - Book a Hotpoint engineer and quote F02 - Published check — Hotpoint identifies dishwasher F02 as a water-fill solenoid-valve failure and recommends an engineer - Published check — No user-level valve replacement is verified - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check; if F02 remains, stop and move to exact-model diagnosis ## Evidence-backed actions - Hotpoint identifies dishwasher F02 as a water-fill solenoid-valve failure and recommends an engineer - No user-level valve replacement is verified - If F02 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Turn off the water supply if the dishwasher is filling unexpectedly. Do not open the inlet valve or test mains-connected components; book an engineer. ## Primary evidence - Source: Hotpoint UK dishwasher error-code support - Source URL: https://www.hotpoint.co.uk/service/dishwasher-repair/error-codes - Source checked: 2026-08-04 - Procedure verified: 2026-08-04 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.