# Hotpoint Washer/dryer combo F01 error Canonical page: https://getfixfault.com/guides/hotpoint-washer-dryer-combo-f01-uk-official-code AI-readable URL: https://getfixfault.com/guides/hotpoint-washer-dryer-combo-f01-uk-official-code.txt Last reviewed: 2026-08-17 ## Direct answer Hotpoint Washer/dryer combo F01: an electronic circuit-board fault that can make functions unavailable. This interpretation applies to Hotpoint washer-dryer combo models covered by the linked UK error-code table in United Kingdom / English. ## Exact scope - Brand: Hotpoint - Appliance: Washer/dryer combo - Error code or indicator: F01 - Model scope: Hotpoint washer-dryer combo models covered by the linked UK error-code table - Region: United Kingdom / English ## What users may observe - F01 is shown on the Hotpoint washer/dryer combo display, indicator, or connected app - The published condition is: an electronic circuit-board fault that can make functions unavailable - The appliance reports the documented supply, interruption, wiring, or power-restoration condition - The important observation is when F01 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — an electronic circuit-board fault that can make functions unavailable - F01 does not alone locate the fault in the outlet, breaker, cord, installation wiring, appliance wiring, or control - Model boundary — apply this interpretation only to Hotpoint washer-dryer combo models covered by the linked UK error-code table ## Verified diagnosis - Photograph the complete F01 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Hotpoint washer-dryer combo models covered by the linked UK error-code table - Confirm that the observed condition matches the published meaning: an electronic circuit-board fault that can make functions unavailable - Published check — Disconnect the appliance from the mains for at least two minutes - Published check — Reconnect it, wait 30 seconds, and try once - Published check — if F01 remains, book a Hotpoint engineer - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check - if F01 remains, stop and move to exact-model diagnosis - Published check — If F01 returns after the listed action, do not repeat the same correction indefinitely - Published check — continue with exact-model diagnosis ## Evidence-backed actions - Disconnect the appliance from the mains for at least two minutes - Reconnect it, wait 30 seconds, and try once - if F01 remains, book a Hotpoint engineer - If F01 returns after the listed action, do not repeat the same correction indefinitely - continue with exact-model diagnosis - If F01 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Follow only the official Hotpoint instructions for the linked United Kingdom appliance table. Disconnect the appliance from the mains for at least two minutes. Reconnect it, wait 30 seconds, and try once; if F01 remains, book a Hotpoint engineer. Stop if there is water, heat, smoke, a burning smell, or unsafe electrical behavior. ## Primary evidence - Source: Hotpoint UK washer-dryer error-code table - Source URL: https://www.hotpoint.co.uk/service/washer-dryer-repair/error-codes - Source checked: 2026-08-17 - Procedure verified: 2026-08-17 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.