# Hotpoint Washer/dryer combo F13 error Canonical page: https://getfixfault.com/guides/hotpoint-washer-dryer-combo-f13-uk-official-code AI-readable URL: https://getfixfault.com/guides/hotpoint-washer-dryer-combo-f13-uk-official-code.txt Last reviewed: 2026-08-17 ## Direct answer Hotpoint Washer/dryer combo F13: a dryer temperature-sensing fault that can prevent clothes drying. This interpretation applies to Hotpoint washer-dryer combo models covered by the linked UK error-code table in United Kingdom / English. ## Exact scope - Brand: Hotpoint - Appliance: Washer/dryer combo - Error code or indicator: F13 - Model scope: Hotpoint washer-dryer combo models covered by the linked UK error-code table - Region: United Kingdom / English ## What users may observe - F13 is shown on the Hotpoint washer/dryer combo display, indicator, or connected app - The published condition is: a dryer temperature-sensing fault that can prevent clothes drying - The measured temperature condition does not match the operating range represented by F13 - The important observation is when F13 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — a dryer temperature-sensing fault that can prevent clothes drying - F13 identifies the temperature condition but does not alone prove a sensor, airflow, heater, refrigerant, wiring, or control fault - Model boundary — apply this interpretation only to Hotpoint washer-dryer combo models covered by the linked UK error-code table ## Verified diagnosis - Photograph the complete F13 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Hotpoint washer-dryer combo models covered by the linked UK error-code table - Confirm that the observed condition matches the published meaning: a dryer temperature-sensing fault that can prevent clothes drying - Published check — Book a Hotpoint engineer and quote F13 - Published check — Do not open fixed panels, test live wiring, or replace an internal component from the displayed code alone - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check - if F13 remains, stop and move to exact-model diagnosis - Published check — If F13 returns after the listed action, do not repeat the same correction indefinitely - Published check — continue with exact-model diagnosis - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check; if F13 remains, stop and move to exact-model diagnosis ## Evidence-backed actions - Book a Hotpoint engineer and quote F13 - Do not open fixed panels, test live wiring, or replace an internal component from the displayed code alone - If F13 returns after the listed action, do not repeat the same correction indefinitely - continue with exact-model diagnosis - If F13 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Follow only the official Hotpoint instructions for the linked United Kingdom appliance table. Book a Hotpoint engineer and quote F13. Do not open fixed panels, test live wiring, or replace an internal component from the displayed code alone. Stop if there is water, heat, smoke, a burning smell, or unsafe electrical behavior. ## Primary evidence - Source: Hotpoint UK washer-dryer error-code table - Source URL: https://www.hotpoint.co.uk/service/washer-dryer-repair/error-codes - Source checked: 2026-08-17 - Procedure verified: 2026-08-17 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.