# Hotpoint Washing machine F18 error Canonical page: https://getfixfault.com/guides/hotpoint-washing-machine-f18-uk-official-code AI-readable URL: https://getfixfault.com/guides/hotpoint-washing-machine-f18-uk-official-code.txt Last reviewed: 2026-08-17 ## Direct answer Hotpoint Washing machine F18: an internal-data error that can disable display or control functions. This interpretation applies to Hotpoint washing-machine models covered by the linked UK error-code table in United Kingdom / English. ## Exact scope - Brand: Hotpoint - Appliance: Washing machine - Error code or indicator: F18 - Model scope: Hotpoint washing-machine models covered by the linked UK error-code table - Region: United Kingdom / English ## What users may observe - F18 is shown on the Hotpoint washing machine display, indicator, or connected app - The published condition is: an internal-data error that can disable display or control functions - The appliance reports the documented supply, interruption, wiring, or power-restoration condition - The important observation is when F18 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — an internal-data error that can disable display or control functions - F18 does not alone locate the fault in the outlet, breaker, cord, installation wiring, appliance wiring, or control - Model boundary — apply this interpretation only to Hotpoint washing-machine models covered by the linked UK error-code table ## Verified diagnosis - Photograph the complete F18 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Hotpoint washing-machine models covered by the linked UK error-code table - Confirm that the observed condition matches the published meaning: an internal-data error that can disable display or control functions - Published check — Disconnect the appliance from the mains for at least two minutes - Published check — Reconnect it, wait 30 seconds, and try once - Published check — if F18 remains, book a Hotpoint engineer - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check - if F18 remains, stop and move to exact-model diagnosis - Published check — If F18 returns after the listed action, do not repeat the same correction indefinitely - Published check — continue with exact-model diagnosis ## Evidence-backed actions - Disconnect the appliance from the mains for at least two minutes - Reconnect it, wait 30 seconds, and try once - if F18 remains, book a Hotpoint engineer - If F18 returns after the listed action, do not repeat the same correction indefinitely - continue with exact-model diagnosis - If F18 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Follow only the official Hotpoint instructions for the linked United Kingdom appliance table. Disconnect the appliance from the mains for at least two minutes. Reconnect it, wait 30 seconds, and try once; if F18 remains, book a Hotpoint engineer. Stop if there is water, heat, smoke, a burning smell, or unsafe electrical behavior. ## Primary evidence - Source: Hotpoint UK washing-machine error-code table - Source URL: https://www.hotpoint.co.uk/service/washing-machine-repair/error-codes - Source checked: 2026-08-17 - Procedure verified: 2026-08-17 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.