# Maytag Dishwasher F8E4 error Canonical page: https://getfixfault.com/guides/maytag-dishwasher-f8e4-official-code AI-readable URL: https://getfixfault.com/guides/maytag-dishwasher-f8e4-official-code.txt Last reviewed: 2026-08-10 ## Direct answer Maytag Dishwasher F8E4: water has been detected in the drip tray. This interpretation applies to Maytag dishwasher models covered by the linked Maytag Product Help article in United States / English. ## Exact scope - Brand: Maytag - Appliance: Dishwasher - Error code or indicator: F8E4 - Model scope: Maytag dishwasher models covered by the linked Maytag Product Help article - Region: United States / English ## What users may observe - F8E4 is shown on the Maytag dishwasher display, indicator, or connected app - The published condition is: water has been detected in the drip tray - Leak protection or a water-detection condition is active; the display does not identify the leak location - The important observation is when F8E4 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — water has been detected in the drip tray - F8E4 confirms the protection condition, not whether the source is a hose, seal, connection, internal component, or installation leak - Model boundary — apply this interpretation only to Maytag dishwasher models covered by the linked Maytag Product Help article ## Verified diagnosis - Photograph the complete F8E4 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Maytag dishwasher models covered by the linked Maytag Product Help article - Confirm that the observed condition matches the published meaning: water has been detected in the drip tray - Published check — Turn off the dishwasher water supply, press Cancel as Maytag describes, and keep the door closed while the drain sequence runs - Published check — Do not restart until the leak or float-switch cause has been assessed - Stop at the published service boundary after these actions - do not add a restart or test cycle that Maytag does not specify for F8E4 - Published check — Give service the F8E4 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that Maytag does not specify for F8E4 ## Evidence-backed actions - Turn off the dishwasher water supply, press Cancel as Maytag describes, and keep the door closed while the drain sequence runs - Do not restart until the leak or float-switch cause has been assessed - Give service the F8E4 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Follow the exact Maytag model instructions. Turn off the dishwasher water supply, press Cancel as Maytag describes, and keep the door closed while the drain sequence runs. Do not restart until the leak or float-switch cause has been assessed. Do not open fixed panels or test live circuits. ## Primary evidence - Source: Maytag official dishwasher support - Source URL: https://producthelp.maytag.com/Dishwashers/Dishwasher/Error_Code_or_Flashing_Lights/Error_Codes/F8E4_-_Dishwasher - Source checked: 2026-08-10 - Procedure verified: 2026-08-10 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.