# Midea Washing machine E10 error Canonical page: https://getfixfault.com/guides/midea-washing-machine-e10-washer-mlh27n5awwc-official-code AI-readable URL: https://getfixfault.com/guides/midea-washing-machine-e10-washer-mlh27n5awwc-official-code.txt Last reviewed: 2026-08-21 ## Direct answer Midea Washing machine E10: water-injection problem. This interpretation applies to Midea MLH27N5AWWC front-load washer covered by the linked official manual in Canada / English manual. ## Exact scope - Brand: Midea - Appliance: Washing machine - Error code or indicator: E10 - Model scope: Midea MLH27N5AWWC front-load washer covered by the linked official manual - Region: Canada / English manual ## What users may observe - E10 is shown on the Midea washing machine display, indicator, or connected app - The published condition is: water-injection problem - The affected fill stage does not receive or confirm the expected water supply while E10 is active - The important observation is when E10 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — water-injection problem - E10 does not distinguish household supply, hose, accessible screen, inlet hardware, wiring, or control until the listed checks are completed - Model boundary — apply this interpretation only to Midea MLH27N5AWWC front-load washer covered by the linked official manual ## Verified diagnosis - Photograph the complete E10 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Midea MLH27N5AWWC front-load washer covered by the linked official manual - Confirm that the observed condition matches the published meaning: water-injection problem - Published check — Check that the water pressure is adequate, straighten the inlet hose, and clean the inlet-valve filter only as the manual permits - Published check — arrange service if E10 returns - Stop at the published service boundary after these actions - do not add a restart or test cycle that Midea does not specify for E10 - Published check — Give service the E10 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that Midea does not specify for E10 ## Evidence-backed actions - Check that the water pressure is adequate, straighten the inlet hose, and clean the inlet-valve filter only as the manual permits - arrange service if E10 returns - Give service the E10 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Follow the exact model manual. Check that the water pressure is adequate, straighten the inlet hose, and clean the inlet-valve filter only as the manual permits; arrange service if E10 returns. Do not open fixed panels or test live circuits. ## Primary evidence - Source: Midea MLH27N5AWWC official washer manual - Source URL: https://www.midea.com/content/dam/midea-aem/ca/laundry/31-cu-ft-front-load-washer-mlh27n5awwc/Manual_MLH27N5AWWC.pdf - Source checked: 2026-08-21 - Procedure verified: 2026-08-21 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.