# Nespresso Lattissima F321/F316 serves a very short cup Canonical page: https://getfixfault.com/guides/nespresso-lattissima-short-coffee-latte-f321-f316 AI-readable URL: https://getfixfault.com/guides/nespresso-lattissima-short-coffee-latte-f321-f316.txt Last reviewed: 2026-08-08 ## Direct answer Nespresso Coffee machine Short cup — Lattissima F321/F316: The cup-size button programming has changed from the factory setting. This interpretation applies to Nespresso Lattissima F321 and F316 machines covered by the Chile support entry in Chile / English. ## Exact scope - Brand: Nespresso - Appliance: Coffee machine - Error code or indicator: Short cup — Lattissima F321/F316 - Model scope: Nespresso Lattissima F321 and F316 machines covered by the Chile support entry - Region: Chile / English ## What users may observe - Short cup — Lattissima F321/F316 is shown on the Nespresso coffee machine display, indicator, or connected app - The published condition is: The cup-size button programming has changed from the factory setting - The controls show the documented lock, pause, or setting state until the exact published control action is completed - If operation no longer matches that description, record the new symptom instead of treating the normal Short cup — Lattissima F321/F316 state as the diagnosis ## Causes or fault boundaries - Manufacturer-defined fault area — The cup-size button programming has changed from the factory setting - Short cup — Lattissima F321/F316 does not prove a failed control board while the documented control state is active - Model boundary — apply this interpretation only to Nespresso Lattissima F321 and F316 machines covered by the Chile support entry ## Verified diagnosis - Photograph the complete Short cup — Lattissima F321/F316 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Nespresso Lattissima F321 and F316 machines covered by the Chile support entry - Confirm that the observed condition matches the published meaning: The cup-size button programming has changed from the factory setting - Confirm the Lattissima model is F321 or F316 - Turn the machine on and allow it to reach operating temperature - Hold the standby button until all four cup buttons flash - Run one coffee and one milk test - Contact Nespresso if the volume remains abnormally short after the reset - Published check — The official remedy is factory reset of cup-size programming - Published check — No pump replacement is justified by a short programmed cup alone ## Evidence-backed actions - The official remedy is factory reset of cup-size programming - No pump replacement is justified by a short programmed cup alone - No component repair is indicated while Short cup — Lattissima F321/F316 remains the documented status “The cup-size button programming has changed from the factory setting” ## Safety boundary The machine and milk outlet may be hot. Keep hands clear during the reset test. ## Primary evidence - Source: Nespresso official Lattissima cup-size FAQ - Source URL: https://www.contact.nespresso.com/faq/cl/en/detail/4633 - Source checked: 2026-08-08 - Procedure verified: 2026-08-08 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.