# Nespresso OriginalLine blinking lights and cold water Canonical page: https://getfixfault.com/guides/nespresso-original-blinking-cold-water-descaling AI-readable URL: https://getfixfault.com/guides/nespresso-original-blinking-cold-water-descaling.txt Last reviewed: 2026-08-08 ## Direct answer Nespresso Coffee machine Blinking and cold water — OriginalLine: The machine is in descaling mode or has not completed warm-up. This interpretation applies to Nespresso Inissia, Essenza Mini, Pixie, and earlier OriginalLine models covered by the Chile support entry in Chile / English. ## Exact scope - Brand: Nespresso - Appliance: Coffee machine - Error code or indicator: Blinking and cold water — OriginalLine - Model scope: Nespresso Inissia, Essenza Mini, Pixie, and earlier OriginalLine models covered by the Chile support entry - Region: Chile / English ## What users may observe - Blinking and cold water — OriginalLine is shown on the Nespresso coffee machine display, indicator, or connected app - The published condition is: The machine is in descaling mode or has not completed warm-up - The controls show the documented lock, pause, or setting state until the exact published control action is completed - If operation no longer matches that description, record the new symptom instead of treating the normal Blinking and cold water — OriginalLine state as the diagnosis ## Causes or fault boundaries - Manufacturer-defined fault area — The machine is in descaling mode or has not completed warm-up - Blinking and cold water — OriginalLine does not prove a failed control board while the documented control state is active - Model boundary — apply this interpretation only to Nespresso Inissia, Essenza Mini, Pixie, and earlier OriginalLine models covered by the Chile support entry ## Verified diagnosis - Photograph the complete Blinking and cold water — OriginalLine display before changing controls or removing power - Confirm that the full model number is covered by this scope: Nespresso Inissia, Essenza Mini, Pixie, and earlier OriginalLine models covered by the Chile support entry - Confirm that the observed condition matches the published meaning: The machine is in descaling mode or has not completed warm-up - Identify whether the machine is Inissia, Essenza Mini, Pixie, or another OriginalLine model - Hold both brew buttons for five seconds only on the supported models - Allow the machine to warm until the lights become steady - Do not brew if water remains cold after the ready state should appear - Contact Nespresso for Lattissima, Expert, or persistent cold-water behavior - Published check — Nespresso documents a mode exit and warm-up boundary - Published check — it does not verify a user heater repair from blinking and cold water ## Evidence-backed actions - Nespresso documents a mode exit and warm-up boundary - it does not verify a user heater repair from blinking and cold water - No component repair is indicated while Blinking and cold water — OriginalLine remains the documented status “The machine is in descaling mode or has not completed warm-up” ## Safety boundary Do not touch internal heater parts. Hot water may appear suddenly after the machine primes. ## Primary evidence - Source: Nespresso official OriginalLine blinking/cold-water FAQ - Source URL: https://www.contact.nespresso.com/faq/cl/en/detail/8406 - Source checked: 2026-08-08 - Procedure verified: 2026-08-08 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.