# Shark Robot vacuum 1164 error Canonical page: https://getfixfault.com/guides/robot-vacuum-shark-1164-rv2800ze AI-readable URL: https://getfixfault.com/guides/robot-vacuum-shark-1164-rv2800ze.txt Last reviewed: 2026-08-10 ## Direct answer Shark Robot vacuum 1164: the shuttle motor is not operating normally. This interpretation applies to RV2800ZE, RV2800YE, and RV2800YS series models covered by the official article in United States / English. ## Exact scope - Brand: Shark - Appliance: Robot vacuum - Error code or indicator: 1164 - Model scope: RV2800ZE, RV2800YE, and RV2800YS series models covered by the official article - Region: United States / English ## What users may observe - 1164 is shown on the Shark robot vacuum display, indicator, or connected app - The published condition is: the shuttle motor is not operating normally - The affected motor, drive, or movement function is stopped or limited while 1164 is active - The important observation is when 1164 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — the shuttle motor is not operating normally - 1164 identifies a drive condition but does not alone prove the motor, inverter, belt, bearing, rotor, wiring, or control failed - Model boundary — apply this interpretation only to RV2800ZE, RV2800YE, and RV2800YS series models covered by the official article ## Verified diagnosis - Photograph the complete 1164 display before changing controls or removing power - Confirm that the full model number is covered by this scope: RV2800ZE, RV2800YE, and RV2800YS series models covered by the official article - Confirm that the observed condition matches the published meaning: the shuttle motor is not operating normally - Published check — Remove the robot from the base, inspect the accessible shuttle area for debris, reseat the robot on the base, and arrange Shark service if the error returns - Stop at the published service boundary after these actions - do not add a restart or test cycle that Shark does not specify for 1164 - Published check — Give service the 1164 photo, full model and serial number, when it appeared, and the result of every published external check - Stop at the published service boundary after these actions; do not add a restart or test cycle that Shark does not specify for 1164 ## Evidence-backed actions - Remove the robot from the base, inspect the accessible shuttle area for debris, reseat the robot on the base, and arrange Shark service if the error returns - Give service the 1164 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Isolate the appliance when safe. Remove the robot from the base, inspect the accessible shuttle area for debris, reseat the robot on the base, and arrange Shark service if the error returns. Do not open fixed panels or test live circuits. ## Primary evidence - Source: SharkNinja official robot-vacuum error-code support - Source URL: https://support.sharkninja.com/article/RV2800-Series-Error-Codes---Shuttle-Motor-Broken-Error-1164 - Source checked: 2026-08-10 - Procedure verified: 2026-08-10 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.