# Shark Robot vacuum 43 error Canonical page: https://getfixfault.com/guides/robot-vacuum-shark-43-rv2700 AI-readable URL: https://getfixfault.com/guides/robot-vacuum-shark-43-rv2700.txt Last reviewed: 2026-08-10 ## Direct answer Shark Robot vacuum 43: the base refill pump has detected an overcurrent condition. This interpretation applies to RV2700 Series Shark Stratos NEVERTOUCH robot-vacuum models covered by the official article in United States / English. ## Exact scope - Brand: Shark - Appliance: Robot vacuum - Error code or indicator: 43 - Model scope: RV2700 Series Shark Stratos NEVERTOUCH robot-vacuum models covered by the official article - Region: United States / English ## What users may observe - 43 is shown on the Shark robot vacuum display, indicator, or connected app - The published condition is: the base refill pump has detected an overcurrent condition - The documented pump or circulation function does not complete as expected while 43 is active - The important observation is when 43 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — the base refill pump has detected an overcurrent condition - 43 identifies the pump or circulation path but does not alone prove the pump, obstruction, wiring, or control failed - Model boundary — apply this interpretation only to RV2700 Series Shark Stratos NEVERTOUCH robot-vacuum models covered by the official article ## Verified diagnosis - Photograph the complete 43 display before changing controls or removing power - Confirm that the full model number is covered by this scope: RV2700 Series Shark Stratos NEVERTOUCH robot-vacuum models covered by the official article - Confirm that the observed condition matches the published meaning: the base refill pump has detected an overcurrent condition - Published check — Switch the base off, check the accessible clean-water tank and refill path for correct seating, and contact Shark if the refill-pump error returns - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check - if 43 remains, stop and move to exact-model diagnosis - Published check — If 43 returns after the listed action, do not repeat the same correction indefinitely - Published check — continue with exact-model diagnosis - Use the result as the decision point: if the documented condition is corrected, complete only the source-listed check; if 43 remains, stop and move to exact-model diagnosis ## Evidence-backed actions - Switch the base off, check the accessible clean-water tank and refill path for correct seating, and contact Shark if the refill-pump error returns - If 43 returns after the listed action, do not repeat the same correction indefinitely - continue with exact-model diagnosis - If 43 returns after the listed action, do not repeat the same correction indefinitely; continue with exact-model diagnosis ## Safety boundary Isolate the appliance when safe. Switch the base off, check the accessible clean-water tank and refill path for correct seating, and contact Shark if the refill-pump error returns. Do not open fixed panels or test live circuits. ## Primary evidence - Source: SharkNinja official robot-vacuum error-code support - Source URL: https://support.sharkninja.com/article/RV2700-Series-Error-Codes---Refill-Pump-Overcurrent-Error-43 - Source checked: 2026-08-10 - Procedure verified: 2026-08-10 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.