# Siemens dishwasher E15 / E3100 code Canonical page: https://getfixfault.com/guides/siemens-dishwasher-e15-e3100-code AI-readable URL: https://getfixfault.com/guides/siemens-dishwasher-e15-e3100-code.txt Last reviewed: 2026-08-03 ## Direct answer Siemens Dishwasher E15 / E3100: Water detected in the base pan; leak protection active. This interpretation applies to Siemens dishwasher models listed by the linked official code table in Ireland / English. ## Exact scope - Brand: Siemens - Appliance: Dishwasher - Error code or indicator: E15 / E3100 - Model scope: Siemens dishwasher models listed by the linked official code table - Region: Ireland / English ## What users may observe - E15 / E3100 is shown on the Siemens dishwasher display, indicator, or connected app - The published condition is: Water detected in the base pan; leak protection active - Leak protection or a water-detection condition is active; the display does not identify the leak location - The important observation is when E15 / E3100 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Water detected in the base pan; leak protection active - E15 / E3100 confirms the protection condition, not whether the source is a hose, seal, connection, internal component, or installation leak - Model boundary — apply this interpretation only to Siemens dishwasher models listed by the linked official code table ## Verified diagnosis - Photograph the complete E15 / E3100 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Siemens dishwasher models listed by the linked official code table - Confirm that the observed condition matches the published meaning: Water detected in the base pan; leak protection active - Stop the dishwasher - Close the water tap - Switch the appliance off - Contact Siemens service - Published check — Siemens identifies E15/E3100 as activated water protection or water in the base - Published check — Its safety guidance is to close the water tap and switch the appliance off - Published check — do not attempt to resolve the leak at home ## Evidence-backed actions - Siemens identifies E15/E3100 as activated water protection or water in the base - Its safety guidance is to close the water tap and switch the appliance off - do not attempt to resolve the leak at home - Arrange Siemens service - Give service the E15 / E3100 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Stop the cycle, close the water supply, and isolate power only if the area is dry and access is safe. Do not tilt or open fixed panels. ## Primary evidence - Source: Siemens Ireland dishwasher error codes - Source URL: https://www.siemens-home.bsh-group.com/ie/customer-service/support/troubleshooting/problems/dishcare/dishcare-error-codes - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.