# Siemens dishwasher E18 / E3200 code Canonical page: https://getfixfault.com/guides/siemens-dishwasher-e18-e3200-code AI-readable URL: https://getfixfault.com/guides/siemens-dishwasher-e18-e3200-code.txt Last reviewed: 2026-08-03 ## Direct answer Siemens Dishwasher E18 / E3200: Water inlet restricted or blocked. This interpretation applies to Siemens dishwasher models listed by the linked official code table in Ireland / English. ## Exact scope - Brand: Siemens - Appliance: Dishwasher - Error code or indicator: E18 / E3200 - Model scope: Siemens dishwasher models listed by the linked official code table - Region: Ireland / English ## What users may observe - E18 / E3200 is shown on the Siemens dishwasher display, indicator, or connected app - The published condition is: Water inlet restricted or blocked - The affected fill stage does not receive or confirm the expected water supply while E18 / E3200 is active - The important observation is when E18 / E3200 appears and whether the exact published action changes that condition ## Causes or fault boundaries - Manufacturer-defined fault area — Water inlet restricted or blocked - E18 / E3200 does not distinguish household supply, hose, accessible screen, inlet hardware, wiring, or control until the listed checks are completed - Model boundary — apply this interpretation only to Siemens dishwasher models listed by the linked official code table ## Verified diagnosis - Photograph the complete E18 / E3200 display before changing controls or removing power - Confirm that the full model number is covered by this scope: Siemens dishwasher models listed by the linked official code table - Confirm that the observed condition matches the published meaning: Water inlet restricted or blocked - Check that the water tap is open - Check the visible inlet hose for kinks - Check the tap for a blockage or limescale - Clean the inlet filter only as the exact model manual permits - Run one test and contact Siemens service if the code returns - Published check — Siemens identifies E18/E3200 as restricted water inlet flow - Published check — Check the water tap, visible inlet hose, and model-approved inlet filter ## Evidence-backed actions - Siemens identifies E18/E3200 as restricted water inlet flow - Check the water tap, visible inlet hose, and model-approved inlet filter - correct an external restriction and test once - If the code returns, arrange Siemens service rather than opening the appliance - Give service the E18 / E3200 photo, full model and serial number, when it appeared, and the result of every published external check ## Safety boundary Switch the dishwasher off before cleaning user-accessible parts. Hidden glass may be present near the filter and pump cover. ## Primary evidence - Source: Siemens Ireland dishwasher error codes - Source URL: https://www.siemens-home.bsh-group.com/ie/customer-service/support/troubleshooting/problems/dishcare/dishcare-error-codes - Source checked: 2026-08-03 - Procedure verified: 2026-08-03 Use only for the stated model and region. The linked manufacturer source remains authoritative, and an error code alone does not prove that a component has failed.