Siemens error codes and fault guides
Browse 10 published, evidence-gated Siemens guides. Each page states the supported model and region, official source, safe checks, and the point to stop.
Siemens fault guides
1–10 of 10
Electronic fault or interrupted programme
E01 / E02 / E03 / E04 / E05 is described by Siemens support as electronic fault or interrupted programme. Exact checks and component access vary by model and region.
Door sensor or electronics fault
E06 is described by Siemens support as door sensor or electronics fault. Exact checks and component access vary by model and region.
Drying-system fault
E07 is described by Siemens support as drying-system fault. Exact checks and component access vary by model and region.
Water level in the rinse bath is too low
E08 is described by Siemens support as water level in the rinse bath is too low. Exact checks and component access vary by model and region.
Internal heating-system fault
E09 / E11 is described by Siemens support as internal heating-system fault. Exact checks and component access vary by model and region.
The dishwasher drying system has reported a fault
Siemens identifies E10 as a fault in the dishwasher drying system and directs owners to Siemens Service for the model-specific repair.
The heating element is calcified or soiled
Siemens identifies E12 as a calcified or soiled heating element and recommends descaling the dishwasher according to its instructions.
Water detected in the base pan; leak protection active
E15 / E3100 is described by Siemens support as water detected in the base pan; leak protection active. Exact checks and component access vary by model and region.
Water-fill system fault
E16 / E3400 is described by Siemens support as water-fill system fault. Exact checks and component access vary by model and region.
Water inlet restricted or blocked
E18 / E3200 is described by Siemens support as water inlet restricted or blocked. Exact checks and component access vary by model and region.