Bosch washing machine E23 / F23 error
E23 / F23 is identified by Bosch support as the aquastop hose has activated because water leakage may be present. Follow the model-scoped external checks and service boundary below.
What E23 / F23 means
Bosch Washing machine E23 / F23: The AquaStop hose has activated because water leakage may be present. This interpretation applies to Bosch washing-machine models covered by the official E23/F23 support article in US / English.
- Model scope
- Bosch washing-machine models covered by the official E23/F23 support article
- Region
- US / English
- Verified
The AquaStop hose has activated because water leakage may be present
Isolate the appliance when safe. Turn off the water tap immediately, stop using the washer, inspect only visible dry areas, and arrange Bosch service to locate the leak. Do not open fixed panels or test live circuits.
Typical symptoms
Fault area and what the code does not prove
Separate the manufacturer-defined condition from components that still need exact-model diagnosis.
Safe next steps
- 1Confirm the exact Bosch Washing machine E23 / F23 model and displayed code before taking action.
- 2Keep the appliance in a safe state and use only the external checks named in the official source.
- 3If the condition remains, stop and arrange qualified service; do not open panels or bypass a safety device.
Step-by-step diagnosis
- 1Photograph the complete E23 / F23 display before changing controls or removing power
- 2Confirm that the full model number is covered by this scope: Bosch washing-machine models covered by the official E23/F23 support article
- 3Confirm that the observed condition matches the published meaning: The AquaStop hose has activated because water leakage may be present
- 4Published check — Turn off the water tap immediately, stop using the washer, inspect only visible dry areas, and arrange Bosch service to locate the leak
- 5Stop at the published service boundary after these actions; do not add a restart or test cycle that Bosch does not specify for E23 / F23
Service-safe actions
- 1Turn off the water tap immediately, stop using the washer, inspect only visible dry areas, and arrange Bosch service to locate the leak
- 2Give service the E23 / F23 photo, full model and serial number, when it appeared, and the result of every published external check
Repair planning
E23 / F23 cost planning: €0 for a safe external inspection; typically €15–€80 for a confirmed external hose or seal. Internal leak diagnosis is commonly €90–€220 before parts.
E23 / F23 time plan: 5–15 minutes to shut off water and inspect externally; allow 30–90 minutes for professional leak tracing.
Dry towels and a shallow tray, Flashlight for external connections, Access to the water shut-off
E23 / F23 parts decision: No part can be selected until the leak location is found. A visibly damaged external hose or seal must match the full Bosch model and connection type.
What not to do
- Do not run another cycle to reproduce an active leak, tilt the appliance, bypass a float switch, or energize wet electrical areas
- Do not run an extra test cycle after the source tells you to stop or arrange service for E23 / F23
Preventive maintenance
- 1Keep user-accessible filters, seals, hoses, and drain connections clean and inspect them periodically for damage or seepage
- 2If E23 / F23 begins recurring despite the documented maintenance, stop repeating the same action and request exact-model diagnosis
Frequently asked questions
What exactly does E23 / F23 identify?
Bosch identifies it as The AquaStop hose has activated because water leakage may be present.
Which action is actually supported for E23 / F23?
Turn off the water tap immediately, stop using the washer, inspect only visible dry areas, and arrange Bosch service to locate the leak.
Can I run another test after E23 / F23?
Not unless the official procedure above explicitly includes it. Complete the safe external actions, then keep the appliance stopped at the service boundary.
Does E23 / F23 prove which part failed?
No. It identifies “The AquaStop hose has activated because water leakage may be present”; parts are selected only after the exact model and failed function are confirmed.
What information should accompany a service request?
The E23 / F23 photo, full model and serial number, the operating stage when it appeared, and the result of each published check.
Did this guide fix your appliance?
Your anonymous response helps us show which repairs work in the real world. One current response is kept per guide.