Electrolux Dishwasher i30 error
i30 is identified by Electrolux support as water-leak detection. Follow the official, model-scoped checks and service boundary below.
water-leak detection
Isolate the appliance when safe. close the water tap, inspect the appliance exterior for water, and arrange service if the leak warning remains Do not open fixed panels or test live circuits.
Typical symptoms
Fault area and what the code does not prove
Separate the manufacturer-defined condition from components that still need exact-model diagnosis.
Safe next steps
- 1Confirm the exact Electrolux Dishwasher i30 model and displayed code before taking action.
- 2Keep the appliance in a safe state and use only the external checks named in the official source.
- 3If the condition remains, stop and arrange qualified service; do not open panels or bypass a safety device.
Step-by-step diagnosis
- 1Photograph the complete i30 display before changing controls or removing power
- 2Confirm that the full model number is covered by this scope: Electrolux UK dishwasher models covered by the linked support article
- 3Confirm that the observed condition matches the published meaning: water-leak detection
- 4Published check — close the water tap, inspect the appliance exterior for water, and arrange service if the leak warning remains
- 5Stop at the published service boundary after these actions
- 6do not add a restart or test cycle that Electrolux does not specify for i30
- 7Published check — Give service the i30 photo, full model and serial number, when it appeared, and the result of every published external check
- 8Stop at the published service boundary after these actions; do not add a restart or test cycle that Electrolux does not specify for i30
Service-safe actions
- 1close the water tap, inspect the appliance exterior for water, and arrange service if the leak warning remains
- 2Give service the i30 photo, full model and serial number, when it appeared, and the result of every published external check
Repair planning
i30 cost planning: €0 for a safe external inspection; typically €15–€80 for a confirmed external hose or seal. Internal leak diagnosis is commonly €90–€220 before parts.
i30 time plan: 5–15 minutes to shut off water and inspect externally; allow 30–90 minutes for professional leak tracing.
Dry towels and a shallow tray, Flashlight for external connections, Access to the water shut-off
i30 parts decision: No part can be selected until the leak location is found. A visibly damaged external hose or seal must match the full Electrolux model and connection type.
What not to do
- Do not run another cycle to reproduce an active leak, tilt the appliance, bypass a float switch, or energize wet electrical areas
- Do not run an extra test cycle after the source tells you to stop or arrange service for i30
Preventive maintenance
- 1Keep user-accessible filters, seals, hoses, and drain connections clean and inspect them periodically for damage or seepage
- 2If i30 begins recurring despite the documented maintenance, stop repeating the same action and request exact-model diagnosis
Frequently asked questions
What exactly does i30 identify?
Electrolux identifies it as water-leak detection.
Which action is actually supported for i30?
close the water tap, inspect the appliance exterior for water, and arrange service if the leak warning remains; Give service the i30 photo, full model and serial number, when it appeared, and the result of every published external check.
Can I run another test after i30?
Not unless the official procedure above explicitly includes it. Complete the safe external actions, then keep the appliance stopped at the service boundary.
Does i30 prove which part failed?
No. It identifies “water-leak detection”; parts are selected only after the exact model and failed function are confirmed.
What information should accompany a service request?
The i30 photo, full model and serial number, the operating stage when it appeared, and the result of each published check.
Did this guide fix your appliance?
Your anonymous response helps us show which repairs work in the real world. One current response is kept per guide.