Dryer error codes and fault guides
Browse 18 published, evidence-gated Dryer guides. Each page states the supported model and region, official source, safe checks, and the point to stop.
Dryer fault guides
1–18 of 18
a dryer temperature-sensor condition
E01 is identified by Bosch support as a dryer temperature-sensor condition. Follow the official, model-scoped checks and service boundary below.
a dryer heating or temperature condition
E02 is identified by Bosch support as a dryer heating or temperature condition. Follow the official, model-scoped checks and service boundary below.
a dryer airflow or condensate condition
E03 is identified by Bosch support as a dryer airflow or condensate condition. Follow the official, model-scoped checks and service boundary below.
a dryer heating-system condition
E06 is identified by Bosch support as a dryer heating-system condition. Follow the official, model-scoped checks and service boundary below.
a dryer control or sensor condition
E08 is identified by Bosch support as a dryer control or sensor condition. Follow the official, model-scoped checks and service boundary below.
The dryer control unit has reported a failure
Gorenje identifies E00 as a control-unit failure. Record the exact model and use qualified service; no control-board replacement is inferred.
a tumble-dryer temperature-sensor failure
E01 is identified by Gorenje support as a tumble-dryer temperature-sensor failure. Follow the official, model-scoped checks and service boundary below.
The dryer has detected a communication error
Gorenje identifies E02 as a communication error. Capture the exact code and model, then use qualified service for the internal connection diagnosis.
The condensate pump is not pumping water to the tank normally
Gorenje identifies E03 as a condensate-pump error. Check the user-accessible condensate path and stop if the code persists.
tumble-dryer system overheating
E04 is identified by Gorenje support as tumble-dryer system overheating. Follow the official, model-scoped checks and service boundary below.
The dryer control unit has reported a failure
Gorenje groups E07 and E08 as control-unit failures. Disconnect the dryer from power and arrange qualified service.
The BLDC motor and control unit are not communicating
Gorenje identifies E11 as a BLDC motor communication error. Do not open the motor circuit; arrange service with the exact dryer model.
The dryer cannot connect to the Wi-Fi network for remote control
Gorenje identifies E17 as a Wi-Fi network connection issue affecting remote control, not the dryer’s normal drying programmes.
The dryer has detected a temperature-sensor failure
Gorenje groups E91, E92, and E93 as temperature-sensor failures. Stop using the dryer and arrange service rather than guessing a sensor part.
The drying cycle was interrupted by a power failure
Gorenje uses PF for a power-supply failure warning. Resume once with Start/Pause, then investigate the household supply if PF returns.
dryer sensor-circuit problem
F9 is identified by Haier support as dryer sensor-circuit problem. Follow the official, model-scoped checks and service boundary below.
abnormal dryer motor
FE is identified by Haier support as abnormal dryer motor. Follow the official, model-scoped checks and service boundary below.
abnormal dryer heating
Fd is identified by Haier support as abnormal dryer heating. Follow the official, model-scoped checks and service boundary below.